Vintage Revolution PedalPro Owner's Manual download pdf (Page 24)

Rev. 2.0 - EN EU - fw 4.22

How to Use Your Pedalino

CompSens:045.4

Comp_Out:034.1

• Once you are done, press the EXIT key [12].

• To change another parameter, press the SET key [11] repeatedly to scroll

through the list of available parameters. You can also use the Favour-

ite switch [4] and the ADES switch [5] to scroll forwards and backwards

through the list of available parameters.

• Use the + key [8] and the – key [9] to adjust the compressor sensitivity to,

for instance, the new value of 45.4.

If the preset save protection is turned OFF (see below) the changes

will be stored in your PedalPro. If it is turned ON, they will be kept

only until you load a different preset.

8.8 PEDALINO PREFERENCES

Every time you power on the Pedalino its preferences are automatically

loaded to allow full control of the device as performed in the prior use.

Therefore, most of the settings that will follow this section will be edited only

the ﬁrst time you turn on your unit.

8.8.1 Favourite preferences

Switching between two and three levels of pressure

Your Pedalino is set to use three levels of pressure when you turn it on for the

ﬁrst time.

• To switch to using two levels of pressure, press the MENU key [10] until the

top line of the display reads ‘Favourites pref.’

v u

ite prF eo s f.

• Press the SET key [11] to access the menu’s conﬁguration options.

The top line of the display will now show the current favourite preset access

mode. In the example shown here, the default 3-levels mode is selected.

Fav=3 lleve /11s

• Use the + key [8] or the - key [9] to switch between 3-levels and 2-levels

favourite access modes.

Fav=2 lleve /11s

Once the favourite preset access mode you want to use is shown on the top

line of the display, the Pedalino is also conﬁgured to operate accordingly.

• Simply press the EXIT key [12] to return to Play Mode.

8.8.2 Changing and customising thresholds

Pedalino comes with two factory-deﬁned sets of thresholds (global thresh-

olds) which determine the degree of force that must be applied to each

control pad in order to reach the three levels that control the various func-

tions (see section 8.1). The two factory-deﬁned sets are ‘soft’ and ‘hard’.

The ‘soft’ set requires the least amount of force to reach the different levels,

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 32 33

No comments

Vintage Revolution PedalPro Owner's Manual Page 24